The rudder angle adaptor which is suitable for all types of vessels can be fitted to a standard resistive rudder angle sender which senses rudder movements and sends the data to the rudder angle adaptor which updates the nmea 2000 network 10 times a second.
Nmea 2000 rudder angle sensor.
The raa100 is used to adapt commercially available resistive rudder angle senders to the nmea 2000 network raa100 rudder angle adapter user s manual.
Looking for a rudder angle sensor to work with a simrad autopilot ap12.
It comes with a 1 metre nmea2000 cable and a 2 metre rudder sensor cable to allow the unit to be placed in a convenient location.
The immediate up to date information can be read on any suitable data display unit.
This allows you to observe rudder angle anywhere on the vessel where there is an nmea 2000 compatible display such as maretron s n2kview vessel monitoring system or maretron s dsm250 dsm410 color graphics displays.
Can be used with a rudder angle sensor with maximal resistance less than 400 ohm including eu or us standard sensors and.
The nmea 2000 rudder angle adapter ydra 01 allows you to connect an existing resistive type rudder angle sensor installed on a rudder and supply nmea 2000 autopilots chart plotters and other devices with the rudder angle.
The arm of the grf 10 is connected to the rudder of the boat and.
The grf 10 uses a magnetic sensor to relay position information eliminating friction that causes other types of sensors to wear out.
The gra 10 allows you to observe rudder angle information on compatible garmin display devices connected to your nmea 2000 network.
Pair this sensor with the ghp 20 or ghp 12 to provide rudder position feedback and to detect and avoid rudder stops while sailing or boating.
The device can be used with a rudder angle sensor with maximal resistance less than 400 ohm including european 10 to 180.
Ideally a nmea2000 type but it can also take an non nmea 2000 sensor a two wire rf300.
Airmar dst800pv n2 with plastic.
With the garmin gra 10 adapter you can convert analog information provided via the rudder angle sensor not included on your boat to your nmea 2000 network.
Pm here or 021 229 4005 thanks.
The mechanical setup of the rudder angle sender is greatly simplified by setting the rudder midships and then adjusting the linkage to the sender until both leds illuminate when the sender is also at midships.
The raa100 is used to adapt commercially available resistive rudder angle senders to the nmea 2000 network.
